GM Inside News Forum banner
1 - 1 of 1 Posts

· Registered
2,217 Posts
the LED bulb you would have to do in both sockets, depends primarily how its set up. if it works on opposing voltages then a normal bulb and a LED will probably not work.

so with those you need to make sure both sides of the circuit are equal. but i dont know how the circuit is set up.

personally i dont have any experience with the LED conversions so i couldnt tell you either way, but i love the way they look, just expensive when they fail, like on caddy's and what not, stock LED is good, not sure on aftermarket.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.