GM Inside News Forum banner

1996 Grand Am window motor

6629 Views 4 Replies 3 Participants Last post by  GMCSonoma
hey guys. Just wondering how hard it is to change a driver side 1996 grand am window motor. I've never replaced a window motor.

My g/fs window got stuck, but later went up, so it might need to be replaced. If the window gets stuck, is there a way to keep it up? I know GM in the 90's especially have had problems with their window motors, including some early gen 2000's..
1 - 2 of 5 Posts
The 92-98 Grand am is totally different than the 99-05....


There is a counterbalance spring to be careful with...motor is riveted to regulator...can be bolted it a blind head bolt is used...
xTooltipElement
Service Information
1998 Pontiac Grand Am | Achieva, Grand Am, Skylark, (VIN N) Service Manual | Body and Accessories | Doors | Repair Instructions | Document ID: 488432
--------------------------------------------------------------------------------

Door Window Regulator Motor Replacement (Front)
Removal Procedure




Remove the door trim panel. Refer to Door Trim Panel Replacement .
Remove enough of the door water deflector to access the window regulator. Refer to Door Water Deflector Replacement .
Remove the door window assembly. Refer to Door Window Replacement .
Remove the window regulator (1). Refer to Door Window Regulator Replacement .
Remove the motor rivets (2) from the window regulator.
Installation Procedure




Install the motor to the window regulator rivets (2).
Install the window regulator (1). Refer to Door Window Regulator Replacement .
Install the door window assembly. Refer to Door Window Replacement .
Install the door water deflector. Refer to Door Water Deflector Replacement .
Install the door trim panel. Refer to Door Trim Panel Replacement .
See less See more
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top