GM Inside News Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
386 Posts
Discussion Starter · #1 ·
This was a complete junker when I got it...I think I saved it. :D
Before...




And after...






 

·
Registered
Joined
·
386 Posts
Discussion Starter · #3 ·
Thanks Swahili...
Here's what I do...
Cover what I need to cover in liquid masking


Draw the flames on and cut them out...with a new sharp knife and very carefully. I try to make them the same on each side. Not being very artsy, I aint always close. LOL


Paint the new colour



Clear it


Start again because for some reason I'm thinking it needs something





And then clear it, polish it with sand paper (3200 min), re clear it, polish it going up to 12000 grit...and the coat it in Future floor polish.


But that was more than you asked...haha...sorry...
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top