Aftermarket gauges - 1988 Delta88 3800 series 1

[oldsdelta88]

Alrighty, I am about to install a tach, temp gauge, oil pressure gauge and a volt meter. IF anyone has a clue where to install the (GREEN) wire that goes to the DIS (ignition) wiring.

the 8th digit in my VIN is C, so this is the type of coil pack i have:

If you could provide a pic or be very detailed in where I would install that wire, would be great!

Next question has to do with the temp gauge. Where on the engine block am i going to look for to drop it in? Pic would be spiffy, otherwise detailed instructions on what to do will also be spiffy!

Third big question is the oil pressure gauge. Where do i install the fittings? I am pretty sure you pull off the wire that signals "LOW OIL PRESSURE" to my dash (then install fittings), but I have no clue where to look yet again . Pics or lots of detail yet again, would be spiffy.

I believe thats all i need to know. The only gauges that came on the car is the speedo and fuel, the rest is warning lights!

Thanks in advance!

[ZillaZ]

All I know is, don't cut the red wire! That's what Bruce Willis always does... err, doesn't do.

Good luck!

[oldsdelta88]

Well now... that was a pointless reply wasnt it.

[RocketImpala]

Well now...looks like you have come onto this board w/ your own little agenda. Maybe you should first try to just participate in a few threads before asking people to do your tech homework for you. Also...put your thread in the right section, that would be spiffy.