[Johnny P]

Originally Posted by jfnz24

Question. How hard is the replacement of the rear wiper motor on a 4door Blazer? The wiper is getting stuck pointing straight up on the rear glass, so I believe it needs replaced. GMCSomona, do you have any diagrams perhaps? Anybody else have any input on how hard it could be? Thanks in advance, and Merry Christmas.

This do it for you?

1. Remove the wiper arm from the shaft.
2. Remove the nut and the spacer from the shaft.

[IMG]file:///C:/Documents%20and%20Settings/OWNER/Desktop/Pics/84714859_files/85136128.gif[/IMG]

1. Remove the interior trim panel.
2. Disconnect the electrical connector from the controller.
3. Remove two screws and the wiper motor from the vehicle.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.

[IMG]file:///C:/Documents%20and%20Settings/OWNER/Desktop/Pics/84714859_files/85136128.gif[/IMG]

1. Install the wiper motor onto the vehicle with two screws while keeping the shaft centered in the tailgate hole. Tighten Tighten two screws to 6.5 N.m (57 lb in) .
2. Connect the electrical connector to the controller.
3. Install the interior trim panel.

[IMG]file:///C:/Documents%20and%20Settings/OWNER/Desktop/Pics/84714859_files/85136127.gif[/IMG]

1. Install the spacer and the nut onto the vehicle. Tighten Tighten the nut to 8 N.m (70 lb in) .
2. Install the wiper arm to the vehicle.